Husqvarna R 112C Operator's Manual page 16

To operate the product, R 112C5
CAUTION:
the gearbox, always stop the product and
disengage the engine before you change
gears.
1. Select cutting height (1–5) with the cutting height
lever.
2. Start the engine.
3. Press the parking brake pedal down and then
release it to disengage the parking brake.
4. Press the clutch pedal down and select a gear.
Select gear 1–4 when you cut grass with the product.
Select gear 4–5 for transport of the product.
CAUTION:
engage immediately, do not use force.
Release the clutch pedal, press it down
again and try to engage the gear again.
Note:
You can start the product on all 5 gears.
5. Slowly release the clutch pedal.
16
To prevent damage to
If a gear does not
6. Lower the cutting deck.
7. To brake, press the parking brake/speed brake
pedal.
To start on a slope, R 112C5
1. Select cutting height (1–5) with the cutting height
lever.
2. Start the engine.
3. Press the parking brake pedal down.
4. Apply full throttle.
5. Press the clutch pedal down and select first gear.
6. Slowly release the parking brake pedal and the
clutch pedal.
To stop the engine
1. Pull the lift lever for the cutting deck rearward to lift
up the cutting deck. The blades stop to rotate.
1466 - 006 - 17.04.2023