Husqvarna R 112C Operator's Manual page 12

10. Set the cutting height lever in a position between 1–
5.
To remove the cutting deck
1. Park the product on level ground.
2. Apply the parking brake.
3. Set the cutting height lever in the servicing position
(S).
4. Put the lift lever for the cutting deck in operation
position.
5. Release the clip and remove the drive belt cover.
12
6. Disengage the spring for the drive belt to loosen the
drive belt tension.
7. Remove the drive belt.
8. For (R 112C, R 112C5): Hold the cutting deck with 2
hands and pull it out. Lift the cutting deck and put it
against the product or a wall.
9. For (R 115C): Hold the cutting deck with 2 hands
and pull it out until it stops.
10. Lift the equipment frame lock to vertical position.
WARNING:
can cause injury to fingers if you do not
operate it carefully. Put the equipment
frame lock in full vertical position.
11. Remove the pin to disconnect the stay from the
cutting deck.
The lock mechanism
1466 - 006 - 17.04.2023