Pre-Operation Check; Set-Up Procedures; Operating Instructions; Shut Down Procedures - Hotsy 1710 SS Operator's Manual

Operations

Pre-Operation Check

• Read machine safety warnings
• Pump oil SAE 10W-40 (non-foaming oil)
• Cold water supply (1gpm over machines rating-
5/8" 20 psi)
• Proper power supply and circuit protection
• Hose, wand, nozzles (nozzle sizes per serial
plate)
• Water filter (intact, non restrictive)
• Read operation instructions
• This machine must be protected from the
elements/freezing.

Set-up Procedures

This machine is intended for indoor use. Machine
must be stored indoors when not in use.
1. Attach a minimum 5/8" garden hose to inlet
connector. Minimum flow should be 1 gpm over the
flow rate of the pressure washer.
2. Attach high pressure hose to discharge nipple
using quick coupler. Lock coupler securely into
place by pulling back coupler collar and inserting it
onto dis-charge nipple, then pushing collar forward
to lock in place.
3. Attach wand to spray gun using Teflon tape on
threads to prevent leakage.
4. Attach connector on discharge hose to spray gun
using Teflon tape on threads.
5. Remove oil plug on top of pressure washer pump
and replace with dipstick supplied. (This may be
installed from the factory.
6. Check oil level on oil dipstick on top of pump. Oil
should be visible one half way up sight glass (10W-
40 non-foaming).
10

Operating Instructions

1. Read safety and preventative maintenance instruc-
2. Turn on water at faucet and pull trigger on spray
3. Push the pump switch on.
4. Turn the variable pressure control handle
5. To apply detergent read "How to Use The

Shut Down Procedures

1. Rinse with clean water to remove any soap
2. Release the trigger on the spray gun. Turn the
3. Turn off water supply.
4. Open spray gun to relieve remaining pressure.
5. Remove water supply hose.
Pressure
Selection of high or low pressure is accomplished by
turning the handle.
Hotsy 1700 Operator's Manual 8.914-380.0 - BJ
tions before starting machine.
gun allowing water to flow until all air has
discharged from system. Check for water leaks;
tighten as needed.
clockwise to increase pressure.
Detergent Injector."
residue, by placing detergent hose into fresh water
bucket and operating injector as described below.
switch off if the machine is going to be left unat-
tended. (Time delay only).
Brass Soap
Nozzle
High
Nozzle
Variable Pressure
Control Handle
NOTE: High pressure nozzle must be inserted at end
of wand to obtain high pressure. to apply soap read
operator's manual.
Variable Pressure
Wand (VP)
Trigger