Rain Collector Installation - ACU-RITE Rain Gauge Instruction Manual

Rain Collector Installation

• To ensure accurate rain measurement, the rain collector MUST be placed on
a flat, level surface.
• Ensure the rain collector is not placed in a low spot that could become
flooded or in an area where there are obstructions above it.
1. Separate the rain collector cover from the rain collector base.
2. Locate the two holes on the rain collector base.
3. Fasten the rain collector base to a sturdy surface, like a deck railing or a
fence post, with screws (included) using hand tools. (Power tools may slip
during installation, causing damage to the rain collector.)
Setup is Complete
The rain collector will now synchronize with the display unit. It may take a few
minutes for synchronization to complete. Please refer to the troubleshooting
section of this manual if anything appears to be functioning improperly.
AT
LEAST
APART
SQUEEZE
SQUEEZE TABS TO OPEN
INSTALL 2 SCREWS USING
HAND TOOLS ONLY.
THEN RE-ATTACH UPPER CASING
7
OK