Rain Collector Installation - ACU-RITE 00875 Instruction Manual

TV

Rain Collector Installation

• To ensure accurate rain measurement, the rain collector MUST be placed on
a flat, level surface.
• Ensure the rain collector is not placed in a low spot that could become
flooded or in an area where there are obstructions above it.
DO NOT
1. Separate the rain collector cover from the rain collector base.
PLACE IN WATER OR
IN UNEVEN OR LOW
2. Locate the two holes on the rain collector base.
SPOTS THAT MAY
3. Fasten the rain collector base to a sturdy surface, like a deck railing or a
BECOME FLOODED.
fence post, with screws (included) using hand tools. (Power tools may slip
during installation, causing damage to the rain collector.)
Setup is Complete
The rain collector will now synchronize with the display unit. It may take a few
minutes for synchronization to complete. Please refer to the troubleshooting
section of this manual if anything appears to be functioning improperly.
3
(.9 m)
DO NOT
PLACE IN AREAS WHERE
PLANT GROWTH CAN
GROW INTO CASE AND
OBSTRUCT RAIN FLOW
THROUGH COLLECTOR
SQUEEZE
SQUEEZE TABS TO OPEN
165 feet maximum
(50 meters)
DO NOT
PLACE IN AN
AREA WITH
OBSTRUCTIONS ABOVE
INSTALL 2 SCREWS USING
HAND TOOLS ONLY.
THEN RE-ATTACH UPPER CASING
7
OK
DO
PLACE ON A LEVEL
SURFACE AT LEAST
3 FEET FROM THE
GROUND WITH NO
OBSTRUCTIONS ABOVE.