Before Installation; Combination Of Outdoor Unit And Indoor Unit; Transportation And Handling - Hitachi RPC-2.0FSR Installation & Maintenance Manual

3.

Before Installation

3.1 Combination of Outdoor Unit and Indoor
Unit
The combination capacity of indoor unit against
the outdoor unit is selected by the outdoor unit
capacity. Refer to the installation manual of
outdoor unit and select the indoor unit and the
outdoor unit to be satisfied the combination unit
number and the combination unit capacity.
3.2 Transportation and Handling
Do not put any material on the product. Do not
step on the product.
• Transport the product as close to the installation
location as practical before unpacking.
Air Inlet Grille
Side Cover
Louver
Do not handle the side cover.
• Do not put any material on the indoor unit.
• Remove the side cover when the indoor unit is
moved after unpacking. If not, the side cover
may be damaged so that may cause injury.
< Removing Side Cover >
(1) Open the air inlet grille.
(2) Remove the fixing screw (M4).
Fixing Screw
(M4)
8
Side Cover
Lower Cover
Side Cover
(3) Push the side cover forward to remove the
hooks and the hooking plate.
Hooking Plate
Hooks
(3 Portions)
(4) Remove the side cover to lift upward.
• When the indoor unit is unpacked, moved
and installed, do not take the air inlet grille,
louver and lower cover. Additionally, do not
apply an excessive force to them. The air inlet
grille, louver and lower cover are deformed or
damaged.
Do not put any foreign material into the indoor
unit and check to ensure that no foreign
material exists in the indoor unit before the
installation and the test run. Otherwise, a fire
or failure, etc. may occur.
● The indoor unit covers are resin made.
Do not apply an excessive force to the resin
covers or make it fall.
● Do not move the louver by hand. If moved,
the louver mechanism will be damaged.
To avoid damage to the resin covers, before lifting
or moving the indoor unit, put a cloth on the resin
covers.
Position for Fixing Screw
A10762300A-rev.1