Installation Instructions; Transportation And Handling Before Installation; Installation Locations Selection - Hitachi AirCore 700 Installation & Maintenance Manual

Single split inverter series outdoor units
Table of Contents

Advertisement

4. Installation Instructions

4. Installation Instructions

4.1 Transportation and Handling before Installation

Transport the product as close to the installation location as practical before unpacking.
Handling Method
When handling the unit, ensure a balance of
the unit, check safety and lift it up smoothly.
(1) Do not remove any packing materials.
(2) Hang the unit under packing condition with
two ropes, as shown in figure below.

4.2 Installation Locations Selection

Before choosing the installation site, obtain the user's approval.
Where it is not exposed to strong wind.
Where airflow is good and clean.
Where it is not exposed to rain and direct sunshine.
Where neighbors are not annoyed by operation sound or hot air.
Where rigid wall or support is available to prevent the increase of operation sound or vibration.
Where there is no risk of combustible gas leakage.
Where it is at least 3m away from the antenna of TV set or radio. An amplifier may be required for the
affected device.
Install the unit horizontally.
Please install it in an area not affected by snowfall or blowing snow. In areas with heavy snow, please
install a canopy, a pedestal and/or some baffle boards.
CAUTION
!
Avoid the following places for installation where air conditioner trouble is liable to occur.
Where there is much machine oil.
Salty places such as seaside.
Where sulfide gas is generated such as a hot spring.
Where there is high-frequency or wireless equipment.
NOTES:
When operating the air conditioner in low outside temperature,
be sure to follow the instruction described below:
Never install the outdoor unit in a place where its air inlet/outlet
side may be exposed directly to wind.
To prevent exposure to wind, install the outdoor unit with its air inlet side facing the wall.
To prevent exposure to wind, it is recommended to install a baffle board on the air outlet side of the
outdoor unit.
Handling
If the product has no package to move, please
protect it with cloth or paper.
-12-
Put cloth or paper
Over 500mm (2.0/2.5/3.0/4.0HP)
Over 1000mm (5.0/6.0/6.5HP)

Advertisement

Table of Contents
loading

Table of Contents