After Use - Silvercrest 295774 Operating Instructions Manual

9) Wipe over the desired area.
If the water tank
NOTE
► Once the water tank
running a little while until the empty water tank
taneous flashing of the red control lamp "high steam level"
control lamp "low steam level"
–
Press the "Steam" button
–
Set the on/off switch
–
Remove the water tank
described in the section "Filling with water".
–
Set the on/off switch
–
Select the desired steam level as described above and press the
"Steam" button
10) When you are finished treating all of the surfaces, press the "Steam"
button
11) Set the on/off switch
12) Remove the power plug from the mains power socket.
NOTE
► If you see streaks on the floor after cleaning with the appliance, this may
be due to the previously used cleaning fluids. Simply clean the floor again
using the steam mop. The smears should now be gone.

After use

1) Allow the appliance to cool down.
2) Remove the pad
3) Remove the water tank
4) Pull the upper cable hook
Wind the cable back around the two cable hooks
Fix the end of the power cable using the cable clip located on the cable.
SDM 1500 C2
becomes empty during use:
has been pumped empty, the pump will continue
to "O".
, fill it and replace the water tank
to "I".
.
to stop steam production.
to "O". The POWER control lamp
.
from the appliance and empty it.
out a little and turn it back upwards.
is indicated by the simul-
and POWER control lamp
again to stop steam production.
/ .
, the green
.
as
goes out.
GB │ MT │
47 ■