Ingeteam
1. Pass the CAN communication cable through the dedicated cable
2. Connect both wires to the terminal J76 as shown in the previous figure,
3. Guide the cable and hold it if necessary on the plastic support.
4. Chech that the connection is tight.
Once all the previous steps have been followed and the inverter is properly wired, the
commissioning of the inverter can be done.
ABS2015IMC04_.docx
gormet.
respecting the printed instructions on the screen-printed electronic card
(CAN_L, CAN_H):
Cable Ethernet
Pin 8
Pin 7
ISS 100TL
ISS 100TL
J76 CAN_L
J76 CAN_H
27