Setting The Camera Outputs - Sony HXC-FB75 Operating Instructions Manual

1
Select the <FOCUS ASSIST> page in the OPERATION
menu.
<FOCUS ASSIST>
INDICATOR : OFF
MODE :
LEVEL :
GAIN :
OFFSET :
AREA MARKER: OFF
SIZE :
POSITION :
POSITION H:
POSITION V:
2
To use a level indicator, select INDICATOR and set to ON.
Setting INDICATOR to ON displays the level indicator for
focusing on the monitor.
You can set the display method with the menu items below.
MODE: Set the type and display position of the indicator.
LEVEL: Set the density and the response speed of the indicator.
GAIN: Set the sensitivity of the indicator.
OFFSET: Set the offset of the focus detection value.
1) Normally, the value is automatically set to the optimum value in
conjunction with the AREA MARKER SIZE set value. Use this
setting when an optimum sensitivity value cannot be obtained,
depending on the shooting environment.
2) Normally, the optimum offset is automatically set in conjunction
with the AREA MARKER SIZE and MASTER GAIN set values.
Use this setting when the optimum offset cannot be obtained,
depending on the shooting environment.
3
To use an area marker, select AREA MARKER and set
to ON.
Setting AREA MARKER to ON displays an area marker
indicating the focus detection area on the monitor.
You can set the size and position of the detection area with the
menu items below.
SIZE: Change the size of the detection area. (If the detection
area size is too large, both the subject and the background
are included in the area, making the indicator display
deviate from the subject.)
POSITION: Roughly set the position of the detection area.
POSITION H: Fine adjustment of the position of the detection
area in the horizontal direction.
POSITION V: Fine adjustment of the position of the detection
area in the vertical direction.
Notes
• The level indicator and effect area marker cannot be displayed at the same
time. The one that was set to ON last takes precedence.
• The area marker and aspect safety marker cannot be displayed at the same
time. The one that was set to ON last takes precedence.
• When displaying the focus assist indicators, check that the flange focal
length (flange back) has been precisely adjusted (see page 21).
05 TOP
c
BOX BTM
40% QUICK
50
50
MIDDLE
CENTER
50
50
1)
2)

Setting the Camera Outputs

You can specify video signals directly output from the camera using
the menu.
Note
The MAIN (camera picture), RET (return video), or VF (the same picture as
that displayed in the viewfinder) settings are common to SD-SDI and VBS.
Different signals cannot be output.
The menu pages used for the output settings are registered in the
USER menu by factory default.
• <SDI OUT> (U17)
• <TEST OUT> (U16)
For details about the USER menu, see "Editing the USER Menu"
(page 35).
Set the items on each page as follows.
Outputting the signal being shot (camera picture)
The same textual information as that displayed in the viewfinder can
be added to the output signal by setting CHARACTER to ON on the
<SDI OUT> or <TEST OUT> page.
To output as HD-SDI
Menu page Page No.
<SDI OUT> M11
To output as SD-SDI
Menu page Page No.
<SDI OUT> M11
To output as VBS
Menu page Page No.
<TEST OUT> M10
Constantly outputting a return video
• When a CCU is connected, one of the signals being supplied to the
CCU can be output from the camera.
• The last selected return signal is output.
To output as HD-SDI
Menu page Page No.
<SDI OUT> M11
30
Item Setting
SDI OUT MAIN
Item Setting
SDI OUT SD-SDI
DOWN MAIN
CONVERTER
SELECT
Item Setting
OUTPUT VBS
DOWN MAIN
CONVERTER
SELECT
Item Setting
SDI OUT RET