Numatic TTB 4055/100T Owner's Instructions Manual page 26

23
24
Fitting the Hose Guide
The vacuum hose has a U-bend clip which creates a U-bend in the hose preventing water spillage when the vacuum
is switched off. If you need to remove the U-bend clip for any reason always ensure it is refitted correctly before you
resume operation.
It is easier to fit the floor-tool if the weight of the machine is resting on the brush. Ensure the brush is fitted first.
Machine Set-Up
Fitting and lowering the Floor Tool
The floor-tool has been designed for quick fitting, allowing easy squee-
gee blade replacement and a safety knock-off feature if the floor-tool gets
snagged, whilst in transit.
Fit the floor-tool and retain using
the detent pin (Fig.23).
The lifting strap is also held by a
detent pin (Fig.24).
Raise the floor-tool for transit
or lower for cleaning operation
using the lifting handle fitted to
the back of the machine (Fig.25).
Refit vacuum hose to the Floor-tool when finished.
Note: DO NOT push the vacuum hose onto the Floor-tool
with the Floor-tool in the raised position.
-
Note:
26
25
For fitting the floor-tool blades
(See Page 40).
30mm
MAX