Table of Contents
Advertisement
!
AFTER THE REMOVAL OF ALL THE PACKAGING, CAREFULLY OPEN AND CHECK THE CONTENTS.
1
3
5
7
8
Quick Set-Up Guide
PLEASE READ BEFORE COMMENCING ANY OPERATION
ENSURE THE BATTERIES ARE CHARGED BEFORE USE.
Using the handle position lever
(Fig.1), move the handle into the
upright position (Fig.2).
Place 50 amp fuse (supplied in the accessory kit)
into the fuse holder using the Maxi Fuse puller
provided (Fig.3).
(Fig.4) Shows 50 amp fuse.
Place the top tank (waste-water) onto the machine (Fig.5) and connect the
vacuum
and floor-tool hose to the separator (Fig.6).
Fit the isolator key and switch the machine on (Fig.7).
Fill the bottom tank (Clean-water) from a tap or hose pipe using the Flexi-Fill
pipe (Fig.8) or remove the filler cap from the rear left of the machine and fill
using a bucket (Fig.9). Add non-foaming cleaning fluid as required
(See page 12). The TTB 4055T / TTB 4552T all have a water capacity of
40 Litres.
9
Great care must be taken to ensure that
contaminants (leaves, hair, dirt, etc.)
are not allowed to enter the clean-water tank
If using a bucket or similar, ensure it is
always clean and free from debris.
20
2
50Amp
Note:
during the filling process.
!
4
6
Advertisement
Table of Contents
