TEFAL Cake Factory Manual page 22

Troubleshooting Guide
Problem
Er00 or Er003
Er01/Er02/Er04/Er05/Er06
The displayed time flashes
The displayed temperature flashes
The illuminated program flashes
The appliance does not close properly
The time has reached 000, but the level of
cooking is insufficient
During cooking, after a modification to the
cooking time, the cooking time automatically
returns to the initial time
After a cooking program has been launched,
it is not possible to modify the cooking time
42
Solution
Appliance failure:
Unplug the appliance and contact your customer service
or a repair centre.
Unplug the appliance and wait a few minutes.
Then plug in your appliance again and turn it on.
If the problem persists, contact your customer service or a
repair centre.
If the displayed time is correct, press OK to confirm.
If the displayed temperature is correct, press OK to
confirm.
If the displayed program is correct, press OK to confirm.
Open the appliance, check that the support grid has not
been left under the non-stick cooking mould.
Check whether you are using a silicone mould taller than
4.5 cm. If this is the case: remove the support grating.
The mould used is not suitable for this appliance: use a
mould that conforms with this appliance's conditions for
use.
At the end of cooking, after having turned off the beep
sound by pressing OK once, close the appliance again and
add some time using the – and + buttons, then confirm by
pressing OK.
After having modified the time, press OK to confirm.
Wait for 2 minutes to elapse after the launch of the
program to modify the time using the – and + buttons.
INHOUDSOPGAVE
• Veiligheidsinstructies
• Beschrijving
• De vormen gebruiken
• Productpresentatie
• Voorbereiding
• Installatie en aansluiten
• Presentatie van de programma's
• A. Het bakprogramma kiezen
• B. Een automatisch programma gebruiken
• C. Een manueel programma gebruiken
• D. Einde van het programma
(automatisch of manueel)
• E. De bakcyclus verlengen
(automatisch of manueel)
• F. Hetzelfde programma nogmaals starten
• G. Herstart een ander programma
• De tijd en het programma tijdens het gebruik aanpassen
• Onderhoud en reiniging
• Bakgids
• Adviezen voor een perfect resultaat
• Probleemoplossing
44
49
50
51
51
51
52
53
54
55
56
56
57
57
58
60
61
62
63
43