Impres 2 Pocket-To-Pocket; Automatic Impres 2 Battery Calibration Or Reconditioning; Impres 2 Battery With Self Calibration And Recondition; Updating Firmware - Motorola PMPN4590 User Manual

Adaptive single user charger
Table of Contents

Advertisement

Available languages

Available languages

4.3

IMPRES 2 Pocket-to-Pocket

When charging IMPRES 2 batteries, the IMPRES 2 charger records charging information within the
battery memory.
If the IMPRES 2 battery is removed from one IMPRES 2 charger pocket and, within 30 minutes,
inserted into another or the same IMPRES 2 charger pocket, then charging resumes at the point where
charging was interrupted. This feature prevents battery over-charging and minimizes the loss of cycle
life.
4.4

Automatic IMPRES 2 Battery Calibration or Reconditioning

The IMPRES 2 charger automatically assesses the condition of an IMPRES 2 battery.
Based on this condition, the charger automatically calibrates or reconditions the battery. Interruption
of either the discharge phase or the full charge phase delays calibration until the next charging
opportunity. Calibration or reconditioning may be enabled or disabled using charger setup mode. When
disabled and the IMPRES 2 battery requires calibration or reconditioning, the LED indicates alternating
amber and green at battery insertion and after the battery is charged.
4.5

IMPRES 2 Battery with Self Calibration and Recondition

4.5.1

Updating Firmware

NOTE: Applies to all IMPRES 2 Gen 2 devices or chargers; which includes Charger Interface
Unit (CIU), Battery Data Reader (BDR), Single-Unit Charger (SUC), Dual-Unit Charger (DUC),
and Multi-Unit Charger (MUC).
Upgrading an IMPRES 2 device or charger to a newer version.
Prerequisites: Remove all inserted batteries from target device or charger.
Procedure:
1 Connect the device or charger to your computer using USB.
The connected device or charger is shown on the main window of the MSI Charger
Reprogrammer.
CAUTION: IMPRES 2 batteries that has this icon on the battery label
do not require periodic calibration and reconditioning when docked into
this IMPRES 2 charger (with software version V2.03 or newer).
NOTE: Ensure that your charger is always updated with the latest
firmware. The Motorola Solutions Charger Reprogrammer application
package can be downloaded from Motorola Online (MOL) or Motorola
Solutions website.
Chapter 4 : IMPRES 2 Batteries and Chargers
MN008031A01-AA
13

Advertisement

Table of Contents
loading

Table of Contents