QOLSYS IQ SHOCK MINI-S Quick Install Manual

IQ SHOCK MINI-S QUICK INSTALL GUIDE
CHOOSE
STEP
1
INSTALLATION
LOCATION
✓
Sliding
glass
doors
Windows
SPECIFICATIONS
Sensor: 2.5"H x 1"W x .5"D
Code outputs: tamper, tamper restore, alarm, alarm restore, low battery.
Transmitter frequency: 319.5 MHz
Supervisory keep-alive interval: 70 minutes.
RF Peak field strength: typical 36000 uV/m at 3m
UL/ULC listed for residential use only
Operating Temperature: -5C~45C
Relative Humidity: 5-95% Non-Condensing
Storage Temperature: -25-70C
Replace battery with exact replacement every 5 years with 3V CR2032
Lithium (x2).
This is a quick guide for experienced installers only. Refer to http://dealers.qolsys.com (login required)
Exterior Doors
✓
✓
✓
✓
DIP
STEP
2
SWITCH
CONFIGURATION
Two dip switches allow you to customize the behavior of this device:
DS#1 - Installer Test Mode:
ON: - Calibrates accelerometer orientation.
- LED is Active for dialing in shock
sensitivity with potentiometer.
- Please note, when test mode is enabled
(ON) the IQ Shock Mini will NOT transmit
signals to the IQ Panel. This mode is only
used for initial installation and calibration
of the shock sensor.
OFF: - Disables installer
test mode.
DS#2 - Reed Switch:
ON:
- Enables reed switch (must be ON for UL
installations).
OFF: - Disables reed switch.
Sensitivity Level:
CLOCKWISE: - More Sensitive
COUNTER-
CLOCKWISE: - Less Sensitive
IMPORTANT NOTE:
The IQ Shock is intended to be installed on doors with or without glass inserts and
on window frames but not on the actual glass surface.
LED
SENSITIVITY
LEVEL
MAGNET
MAX MIN
DIP
SWITCHES