QOLSYS iQ Tilt S Quick Install Manual

IQ TILT S-LINE QUICK INSTALL GUIDE
OVERVIEW
The IQ Tilt is designed to tell you whether an overhead garage door is open or closed. The tilt
sensor houses a cylinder with a metal bearing inside. When the sensor is tilted, the bearing rolls
down the cylinder towards from the metal contacts. This connects a circuit and sends a signal to
the panel saying that the garage has been opened. NOTE: Improper orientation and/or placement of
the bearing cylinder may result in false alarms or incorrect signals.
REMOVE
STEP
1
BATTERY
TABS
This is a quick guide for experienced installers only. Refer to http://dealers.qolsys.com (login required)
STEP
APPLY
2
ADHESIVE

SPECIFICATIONS

Sensor: 2.5"H x 1"W x .5"D
Wireless signal range: 600ft (200M), open air.
Code outputs: tamper, tamper restore, alarm, alarm
restore, low battery.
Transmitter frequency: 319.5 MHz
Unique code ID
Supervisory keep-alive interval: 70 minutes.
RF Peak field strength: typical 36000 uV/m at 3m
STEP
TUBE
3
ORIENTATION
Operating Temperature: -10C~50C
Relative Humidity: 5-95% Non-Condensing
Storage Temperature: -40-80C
The cylinder should be
angled inside the
Replace battery with exact replacement every 5 years
sensor housing as
with 3V Lithium (x2).
shown
(2) -Panasonic CR2032
-Energizer CR2032
-Duracell DL2032