Table of Contents 1. Important Safety Instructions 2. Application 1.1 Intended use 1.2 Non-intended use 3. Technical Data 4. Your EXAMO100 Testing Device 4.1 Type plate and identification 4.2 Scope of delivery (standard equipment in the storage box) 4.3 Overview of device parts 5. Commissioning the EXAMO100 5.1 Work environment and safety 5.2 Preparation and operation 5.3 Testing with EXAMO100...
The device should only be operated only by trained specialists or under their supervision. Children are not permitted to operate the device. You need a cordless drill to operate the EXAMO 100. Read the operating instructionsof the manufacturer and observe its warning and safety instructions.
The EXAMO 100 tensile tester is to be used for testing plastic membranes made of PE-HD and PE-LD with a thickness of 0.5–3.0 mm and a maximum width of 25 mm. To use the EXAMO 100 testing device, a cordless drill with bit holder equipped with a gear selector switch for the slow speed stage is required.
The type designation and the series identification are marked on the type plate (6) of the device as attached. Please transfer this information to your instruction manual. In the event of any inquiries to our representatives or authorized Leister Service Centers, please always refer to this information. Model: Serial no.:...
4.3 Overview of device parts 1. Hexagonal adapter 4. Clamping lever (connection for cordless drill with bit holder) 5. Clamping slide 2. Handle 6. Type plate 3. Clamping jaws...
5. Commissioning the EXAMO100 5.1 Work environment and safety Warning Hold the testing device with one hand by the handle provided. Incorrect handling can lead to injuries. The cordless drill may only be switched on when the testing device is being held by the handle. Keep handles and grip surfaces dry, clean and free from oil and grease. Slippery handles and grip surfaces do not permit safe operation and control of the device in unforeseen situations. Start the testing process with a slow rotating movement.
• Set the gear selector switch of the cordless drill to the slowest setting. • The test piece (coupon) must be prepared so that it does not have any unclean cuts or damage. Ideally, the test piece is punched with the COUPON CUTTER500 from Leister. 5.3 Testing with EXAMO100 •...
2. Connect the cordless drill incl. bit holder to the EXAMO100 and pull out the test coupon 3. Retract the clamping slide (5) to original position and remove cordless drill incl. bit holder 4. Remove the remnants of the test coupon EXAMO 100 Quick Guide Operating Instructions: leister.link/qg-dlp-examo-100 QG EXAMO 100 / Art. 167.613 / 12.2022...
8. Maintenance • Repairs are to be performed exclusively by authorized Leister Service Centers. • Leister Service Centers guarantee a professional and reliable repair service within 24 hours with original spare parts in accordance with circuit diagrams and spare parts lists.
Kaegiswil, 03/27/2023 Bruno von Wyl, CTO Pascal Bösch, VP R&D UK Declaration of Conformity Leister Technologies AG, Galileo-Strasse 10, 6056 Kaegiswil, Switzerland confirms that this product, in the versions as brought into circulation through us, fulfils the requirements of the following UKStatutory Instrument. UK Statutory Instrument: 2008 No. 1597...