Table of Contents
Advertisement
5.
Press (C).
Confirm that the mode hand is stopped at
12 o'clock, and check if the day is
indicated properly.
Mode hand
Day (Operation start day)
6.
If the mode hand and/or the day indicator
is out of alignment, rotate the crown to
move the mode hand to 12 o'clock and the
day to the center of the indicator window.
The movement range of the mode hand
●
and day indicator is limited when you
rotate the crown. The maximum left-
right movement of the mode hand is 180
degrees in either direction. The day
indicator moves only slightly.
After the mode hand and day indicator
●
are in the positions you want, advance
to step 9 of this procedure. If you are
unable to make the adjustments you
want, go to step 7.
7.
Press (C).
Confirm that the day indicator shows 1.
Day
Changing the date setting will cause the
●
mode hand to rotate repeatedly. In
some cases, the mode hand may
continue to rotate for about 5 minutes.
Hand and Day Indicator Movement
l
8.
If 1 is not shown for the day, rotate the
crown until 1 is shown for the day.
The mode hand moves in conjunction
●
with crown rotation. Move the mode
hand to 12 o'clock.
9.
Push the crown back in and then lock it.
Operation Guide 5625
Note
Leaving the crown pulled out for more
●
than approximately 30 minutes without
performing any operation will
automatically cause the adjustment
operation to become disabled. If this
happens, push the crown back in to its
normal position and then pull it out
again to restart the procedure from the
beginning. Pushing the crown in to its
normal position part way through the
alignment procedure will cause the
hands to return to their normal position.
Any alignment you performed up to
that point will be applied.
Other Settings
This section explains other watch settings you
can configure.
Resetting Watch Settings
This section explains how to return the watch
settings below to their initial factory defaults.
Watch Settings
●
Stopwatch
●
Timer
●
Alarm
●
1.
Enter the Calendar Mode.
Navigating Between Modes
l
2.
Loosen the crown and then pull it out to the
second click.
3.
Hold down (C) for at least five seconds
until the second hand points to 12 o'clock
twice.
4.
Push the crown back in and then lock it.
Second hand
Crown
International Travel
When you enter another time zone, the watch
will adjust its time setting to your current
location in accordance with the time zone of
your phone. When you reach your destination,
disable the watch Airplane Mode.
1.
When you reach your destination,
establish a connection between the watch
and your phone.
Using the Watch in a Medical Facility or
l
Aircraft
After you disable the watch's Airplane
Mode, it will adjust its time setting to the
time in your current location.
If you want to trigger immediate time
●
adjustment, refer to the information at
the link below.
Triggering Immediate Time
l
Adjustment
17
Advertisement
Table of Contents
