Table of Contents
Advertisement
Hook
CAUTION:
When installing the hook, always
secure it with the screw firmly. If not, the hook
may come off from the tool and result in the personal
injury.
CAUTION:
Use the hanging/mounting parts
for their intended purposes only. Using for unin-
tended purpose may cause accident or personal
injury.
CAUTION:
Do not hang the hook from the
waist belt. Dropping the stapler, which is caused by
the hook accidentally coming out of place, may cause
unintentional firing and result in personal injuries.
Fig.9
The hook is convenient for temporarily hanging the tool.
This can be installed on either side of the tool.
To install the hook, insert it into a groove in the tool
housing on either side and then secure it with a screw.
To remove, loosen the screw and then take it out.
1
2
3
Fig.10
► 1 . Groove 2. Hook 3. Screw
OPERATION
Testing safety system
WARNING:
in working order before operation. Failure to do
so may cause personal injuries.
1
Fig.11
► 1 . Trigger-lock button 2. Switch trigger 3. Contact
element 4. Magazine
Test safety system as follows for possible fault before
operation.
1.
Unload staples from the tool and keep the maga-
zine opened.
2.
Install the battery cartridge and release the trigger
lock.
3.
Pull the switch trigger without touching the contact
element against the material.
4.
Touch the contact element against the material
without pulling the switch trigger.
If the tool works in case 3 or 4 described above, safety
system is not functioning properly. Stop using the tool
immediately and ask your local Makita Service Center.
Driving staples
WARNING:
ing electrical cables. It is not designed for electric
cable installation and may damage the insulation of
electric cables thereby causing electric shock or fire
hazards.
WARNING:
element firmly on the material until the staple is
driven completely. Unintentional firing may cause
personal injuries.
WARNING:
when operating the tool. Failure to do so may cause
injury.
CAUTION:
Hold the tool firmly during
operation.
CAUTION:
Do not use the tool beyond the
continuous operating time allowed. It otherwise
may cause damages to the tool resulting in personal
injury.
10 ENGLISH
Make sure all safety systems are
2
3
4
Do not use this stapler for fasten-
Continue to place the contact
Keep your face away from the tool
Advertisement
Table of Contents
