Table of Contents
Advertisement
NOTICE:
The tool will not restart fastening
after five seconds no switch operation while the
contact element is placed on the workpiece. Pull
the contact element free from the workpiece and
reposition it in place to restart fastening.
You can operate the tool in either way of "single
sequential actuation" or "contact actuation".
Single sequential actuation:
In this mode, you can drive one staple by one sequen-
tial operation.
1.
Release the trigger lock.
2.
Place flat the contact element on the material.
3.
Hold the depth guide firmly against the material.
1
Fig.12
► 1 . Trigger-lock button 2. Contact element 3. Depth
guide
4.
Pull the switch trigger fully to drive a staple.
1
Fig.13
► 1 . Switch trigger
2
3
5.
Release your finger from the switch trigger before
moving the contact element from the material.
You can also sequentially drive staples by pulling the
switch trigger while dragging the tool to the next area
with the contact element pressed against the material.
Fig.14
Contact actuation:
In this mode, you can drive staples consecutively.
1.
Release the trigger lock.
2.
Pull the switch trigger.
1
2
Fig.15
► 1 . Trigger-lock button 2. Switch trigger
3.
Place flat the contact element on the material to
drive a staple.
11 ENGLISH
Advertisement
Table of Contents
