Makita ST001G Instruction Manual page 8

Switch action
CAUTION:
Before installing the battery car-
tridge into the tool, always check to see that the
switch trigger actuates properly and returns to
the "OFF" position when released.
CAUTION:
When not operating the tool,
depress the trigger-lock button from B side to
lock the switch trigger in the "OFF" position.
To prevent the switch trigger from accidentally pulled,
the trigger-lock button is provided.
To pull the switch trigger, depress the trigger-lock button from A side.
After use, always press in the trigger-lock button from B side.
B
2
Fig.3
► 1 . Trigger-lock button 2. Switch trigger
Adjusting depths of stapling
WARNING:
Always make sure that your fingers
are not placed on the switch trigger or the contact
element and that the battery cartridge and staples
are removed before adjusting the depths of stapling.
Depths of stapling can be changed by lifting and lowering the
depth guide at the bottom of the tool. Turn the adjuster in the
direction shown in the figure to adjust the depth guide position.
Settings toggle through 5 ranges of depth in 0.6 mm increments.
1 2
Fig.4
► 1 . Adjuster 2. Depth guide
Lighting up the lamp
source of light directly.
Pull the switch trigger or actuate the contact element
to light up the lamp. The lamp remains lit for up to 15
minutes while pulling the switch trigger or actuating the
contact element. The lamp goes out approximately 10
seconds after releasing the switch trigger and the con-
tact element.
1
Fig.5
► 1 . Lamp
A
NOTICE:
lens of the lamp. Be careful not to scratch the lens
of lamp, or it may lower the illumination.
NOTICE:
battery becomes low on power even while the
lamp remains lit. In this case, charge the battery
cartridge.
NOTICE:
battery becomes overheated or detects an error
during driving operation. Take the following steps
to clear possible causes.
1.
2.
If the tool does not restart after recovery, ask your
local Makita Service Center.
8 ENGLISH
CAUTION:
Do not look in the light or see the
Use a dry cloth to wipe the dirt off the
The tool may not fire staples after the
The lamp starts flashing when the tool/
Keep the battery installed in the tool, and let
the tool and battery together cool down until
the lamp stops flashing.
Remove the battery cartridge from the tool,
and then clear jams inside the magazine.
1