Advertisement
Zenith STOL CH 750
PREFLIGHT INSPECTION (cntd)
D Left wing leading edge, left main gear leg:
1. Check left door for general condition, proper operation and locking
2. Check gear leg for structural condition and secure attachment
3. Check wheel tire condition and pressure
4. Drain gascolator near left main gear leg
5. Drain wing tank
6. Check fuel level visually and memorize amount
7. Check fuel cap for security, undamaged seal and tight fit
8. Check front spar bolt for security
9. Check inspection covers for secure attachment
10. Check leading edge and slats for any damage
11. Check attachments bolts of slats for security
12. Check Pitot/AOA Probe for any obstruction and remove cover
13. Check wing for structural condition
14. Check both wing struts for damage/bending and secure connection
15. Check jury struts for damage/bending and secure connection
16. Check wing tip area for damage and wear
17. Check condition and security of nav/strobe lights
E Left wing trailing edge and control surfaces:
1. Check flaperon and hinges for structural condition and secure
attachment
2. Check free movement of flaperon
3. Check rear spar bolt for security
4. Check flaperon push rod for security, integrity and freedom
F Rear fuselage right side:
1. Check rear fuselage skin for stress, cracks, dents and loose rivets
2. Check static port, must be free and unobstructed
3. Check COM and ELT Antenna
Issued: 01.02.2020
Airplane Flight Manual
Revision 0, Dat. 01.02.2020
HB-YRC
Page 39-93
Advertisement
