Advertisement
1. The bumper is worn.
The nails are
2. The air pressure is
being driven
too deep.
3. The depth
The tool does
1. The air supply is
not operate
properly - it
2. Lubrication is
does not
drive the nails
3. The O-rings or seals
or operates
sluggishly.
4. The e haust de ector
1. The bumper is
The tool skips
2. There is dirt in the
nails.
3. Nails cannot move
4. The O-ring on the
5. The cylinder cover
too high.
adjustment knob is
not adjusted
properly.
inadequate.
inadequate.
are worn or damaged.
in the cylinder head is
blocked.
worn, or the spring
is damaged.
front plate.
freely in the magazine
due to dirt or wear.
piston is worn or dry
or lubrication is
insufficient.
seal Is leaking.
1. Replace the bumper.
2. Adjust the air pressure.
3. Adjust the depth setting by turning
the depth adjustment knob
counterclockwise (see section
Adjusting nail depth for more
detailed instructions).
1. Verify that the air supply is
adequate.
2. Pour up to 6 drops of oil into the air
inlet.
3. Inspect and replace O-rings or
seals.
4. Replace the damaged internal parts.
1. Replace the bumper or spring.
2. Clean the drive channel on the
front plate.
3. Clean the magazine.
4. Replace the O-ring.
5. Replace the sealing washer.
Advertisement
