Advertisement
the Workpiece Contact will cause a fastener to be driven.
⚠
WARNING
Extreme care should be taken because a nail will be
driven when the firing head contacts any surface.
Remove the non-jammed nails that are stored in the tool's magazine.
Operate the magazine latch and slide the pusher back to open the
magazine for checking the jammed nails.
Use pliers or any appropriate tool to remove the jammed nails.
Close the magazine cover and slide the pusher to its original position.
Reload the nails into the tool magazine.
Reconnect the air supply line to the tool's air inlet.
Test re 3 to 5 nails into a piece of scrap wood in order to ensure a proper
operation.
If it is necessary to store the tool for an extended period of time, apply a generous
amount of lubrication before storing.
The tool should be allowed to run for approximately 30 seconds after lubricating, in
order to ensure that the lubrication is uniformly distributed throughout the tool.
Advertisement
