Advertisement
2.Hold the Brad Nailer rmly with
onehand and use the other hand
to press the latch (1) on the magazine
(2) and slide it back.
3.Insert a strip of nails (1) into the magazine.
After ensuring that the points of the
nails are facing down, close the magazine.
4.Plug in compressor, turn it on, set the
pressure regulator to 90 PSI, attach one
end of the air hose to the compressor
and the other end of the air hose (2) to
the tool (1). Use plumber's tape to
prevent air leaks.
5.Test the driving depth of the
tool against a sample piece of
wood by pressing the
trigger (1) before working on the
workpiece.
The safety tip must be in contact with the workpiece before
activating the tool.
Do not operate the tool if the nails are not loaded, as doing so
may damage the tool.
Do not re nails into the air, as doing so may cause injury to
the operators or others, apart from damaging the tool.
Load the correct type of nails only. Failure to comply could lead
to serious injury or loss of life.
Disconnect the tool from the air supply line.
Advertisement
