Advertisement
The Brad Nailer has a depth adjustment dial
below the trigger to adjust the ring depth of
the fasteners.
Note: Refer to the graphic imprinted below
the trigger and adjust the ring depth
accordingly.
Turn the depth adjustment dial
counterclockwise (with the discharge area of
the tool facing away from the operator).
Turn the depth adjustment dial clockwise (with
the discharge area of the tool facing away from
the operator).
The Nailer has two firing modes: Single-Sequential actuation for
single firing, or Contact / bump actuation for repetitive, fast
firing of nails.
Each mode requires a different method of operation:
Single Firing: To operate the tool in this manner, first position the
Workpiece Contact on the work surface, WITHOUT PULLING
THE TRIGGER. Depress the Workpiece Contact until the
Workpiece contact (nose of tool) touches the work surface
and then pull the trigger to drive a fastener. Do not press the
tool against the work with extra force. Instead allow the tool to
recoil off the work surface to avoid a second, unwanted
fastener. Remove your finger from the trigger.
Contact or Bumping actuation mechanism: To operate the tool
in this manner, hold the tool with the Workpiece Contact
pointing towards but not touching the work surface. Pull the
trigger and then tap (bump) the Workpiece Contact against the
work surface using a bouncing motion. Each depression of
Advertisement
