Table of Contents
Advertisement
Color Control GX Manual
4.8. DC Link Box
• Connect the DC Link Box with the supplied RJ12 cable. Then connect the BMV-700 to the CCGX.
4.9. VE.Can Resistive Tank Sender Adapter
See the
VE.Can resistive tank sender adapter
product page for details about the adapter.
• To connect a product with a VE.Can port, use a
standard RJ45
UTP cable
• Don't forget to terminate the VE.Can network on both ends using a
VE.Can
terminator. A bag with two terminators is supplied
with each VE.Can product. They are also
available separately
(ASS030700000). (Available with straight or elbow connectors).
• Make sure that the CAN-bus is powered, see the
Power chapter in the Tank Sender Adapter manual
for details.
4.10. Connecting a GX Tank 140
The GX Tank 140 is an accessory for our range of GX system monitoring products.
It takes readings from up to four tank level sensors.
Tank levels can be read-out locally in the system, as well remotely through our VRM Portal.
The GX Tank 140 is compatible with current senders (4 to 20mA) as well as voltage senders (0 to 10V). The connection to the GX
device is via USB, which is also how the GX Tank is powered: no additional power wires required.
To make wiring the tank sender as simple as possible, two of the four inputs provide a 24V power supply, to power the sender.
Using the other two channels requires an external power supply, and there is a power in terminal together with fused outputs to
facilitate that.
Upper and lower limits are configurable, to allow using senders that provide only part of the scale, for example 0 to 5V.
For marine applications, the GX device can transmit these tank levels on the NMEA 2000 network to be picked up by other
displays such as an MFD.
The
GX Tank 140 product page links to the complete documentation
of this product.
Page 12
Connecting Victron products
Advertisement
Table of Contents
Troubleshooting
