Care And Maintenance - Hilti SFD 2-A12 Operating Instructions Manual

6.7 Drilling
1. Set the torque and operating mode selector ring to the
2. Set the forward/reverse switch to the "forward" position.
6.8 Switching on
▶ Press the control switch.
Speed can be controlled steplessly right up to maximum by varying
how far the control switch is pressed in.
6.9 Switching off
▶ Release the control switch.
6.10 Removing the accessory tool
1. Set the forward/reverse switch to the middle position or remove the
battery from the power tool.
2. Pull the accessory tool out of the chuck.
7

Care and maintenance

WARNING
Risk of injury with battery inserted !
▶ Always remove the battery before carrying out care and maintenance
tasks!
Care and maintenance of the tool
• Carefully remove stubborn dirt.
• Clean the air vents carefully with a dry brush.
• Use only a slightly damp cloth to clean the casing. Do not use cleaning
agents containing silicone as these can attack the plastic parts.
Care of the Li­ion batteries
• Keep the battery free from oil and grease.
• Use only a slightly damp cloth to clean the casing. Do not use cleaning
agents containing silicone as these may attack the plastic parts.
• Avoid ingress of moisture.
Maintenance
• Check all visible parts and controls for signs of damage at regular intervals
and make sure that they all function correctly.
• Do not operate the product if signs of damage are found or if parts
malfunction. Have it repaired immediately by Hilti Service.
• After cleaning and maintenance, fit all guards or protective devices and
check that they function correctly.
*2235440*
Printed: 19.08.2019 | Doc-Nr: PUB / 5509398 / 000 / 00
2235440
symbol.
English 11