Adding Gear Oil - KTM 125 EXC 2016 Owner's Manual

18 SERVICE WORK ON THE ENGINE
1 0 0 1
18.5

Adding gear oil

Info
Too little gear oil or poor-quality gear oil results in premature wear of the transmission.
The gear oil level must be checked when the engine is cold.
Main work
–
Remove filler plug
Gear oil
(All 125/200
models)
Gear oil
(All 250/300 mod-
els)
–
Mount and tighten the oil filler plug.
401955-10
Danger
Danger of poisoning Exhaust gases are toxic and inhaling them may result
in unconsciousness and/or death.
–
–
Start the engine and check that it is oil-tight.
Finishing work
–
Check the gear oil level. (
–
Install the engine guard. (
Preparatory work
–
Park the motorcycle on a level surface.
Main work
(All 125/200 models)
–
Remove screw
B02173-10
(All 250/300 models)
–
Remove screw
102298-10
–
Remove filler plug
–
Add gear oil until it emerges from the opening used to check the gear oil level.
Engine oil (15W/50) (
–
Mount and tighten the gear oil level check screw.
Guideline
(All 125/200 models)
Screw, gear oil level check
401955-11

and fill up with gear oil.
0.70 l (0.74 qt.)
0.80 l (0.85 qt.)
When running the engine, always make sure there is sufficient ventila-
tion, and do not start or run the engine in an enclosed space without an
effective exhaust extraction system.
p. 111)
p. 80)
 from the opening used to check the gear oil level.

from the opening used to check the gear oil level.

.
p. 140)
Engine oil (15W/50) ( p. 140)
Engine oil (15W/50) ( p. 140)
M6 10 Nm
(7.4 lbf ft)
113