Ebyte E18-DTU Series User Manual page 24

Chengdu Ebyte Electronic Technology Co., Ltd. E18-DTU Series User Manual
terminal device, and the Target SN is the binding record of the router device, indicating that the binding setting is
successful.
(6) On the host computer interface of the terminal device, set the "target short addr" to "FE FF" (0xFFFE is an
invalid short address, after setting the target short address to an invalid short address, the device automatically
defaults the transparent transmission target to bind Address), click "set". Then enter "01 00" in "Add Group", click
"Add Group", add the terminal device to 0x0001 group , and then click "Trans mode".
(7) On the host computer interface of the router device, set the "DPORT" to "00" (the target port is set to 0x00,
which means multicast mode), and then set the target short address to "01 00" (the target short address in multicast
mode is Multicast address, here multicast to group 0x0001), click "set", the router will send transparent
Copyright © 2012–20 23 , Chengdu Ebyte Electronic Technology Co., Ltd.
23