Gas Train Electricity Supply - Riello BS2F Installation, Use And Maintenance Instructions

5.6.3

Gas train electricity supply

Disconnect the electrical power using the main
switch.
DANGER
Check that there are no gas leaks.
Pay attention when handling the train: danger of
crushing of limbs.
Make sure that the gas train is properly installed
by checking for any fuel leaks.
The gas train's power cables can be fed to the right or left of the
burner, as illustrated in Fig. 11.
Depending on the entry point, the cable clamp with pressure test
point 1) and simple cable clamp 2) may need swapping over.
Consequently, you must make sure:
➤ cable clamp 1) is positioned correctly;
➤ the tube is positioned correctly so that there are no restric-
tions likely to impede air flowing to the pressure switch.
If necessary, cut the tube to the right size.
WARNING
20071805
Installation
1
2
D7113
13 GB
2
1
Fig. 11