Table of Contents
Advertisement
Parameter
Threshold
Note:
Refer to chapter 6.4.1.1 Video Detect for other parameters.
•
Alarm (WV-V2530LK)
6.4.3.
The alarm of the [Alarm] interface is shown as in Figure 6-37.
Refer to the following sheet for detailed information.
Parameter
Enable
Relay-in
Working period
Anti-dither
Sensor type
Record
Record Delay
1-100 level adjustable, it can be used to set the intensity of filtered
environmental sound. If the environmental noise is louder, then it needs to set
the value higher. Users need to adjust according to the actual environmental
test.
Figure 6-37
After enabled, relay activation will work.
You can select only Alarm1.
•
This function becomes activated in the specified periods.
There are six periods in one day. Draw a circle to enable corresponding
•
period.
Select date. If you do not select, current setup applies to today only.
•
You can select all week column to apply to the whole week.
•
Click the [OK] button, system goes back to motion detection interface.
Click the [Save] button to exit.
Note: User can set via dragging mouse while not releasing left mouse.
System only memorizes one event during the anti-dither period. The value
ranges from 0s to 100s.
There are two options: NO/NC. Switch from NO to NC means enabling
alarm; Switch from NC to NO means disabling alarm.
System auto activates motion detection channel to record once alarm
occurs (working with motion detection function).
System can delay the record for specified time after alarm ended. The value
ranges from 10s to 300s.
Note
Function
52
Advertisement
Table of Contents
