Zanussi ZOB38903XD User Manual page 21

Problem
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The lamp does not operate.
The oven does not heat up. The
fan does not operate. The display
shows or .
The display shows an error code
that is not in this table.
It takes too long to cook the
dishes or they cook too quickly.
Steam and condensation settle
on the food and in the cavity of
the oven.
Service data
If you cannot find a solution to the problem
yourself, contact your dealer or an Authorised
Service Centre.
Model (MOD.)
Product number (PNC)
Serial number (S.N.)
www.zanussi.com
Possible cause
The automatic switch-off is acti-
vated.
The Child Lock is on.
The fuse is blown.
The lamp is defective.
The demo mode is activated.
There is an electrical fault.
The temperature is too low or too
high.
You left the dish in the oven for
too long.
We recommend that you write the data here:
Refer to "Automatic switch-off".
Refer to "Using the Child Lock".
Make sure that the fuse is the
cause of the malfunction. If the
fuse is blown again and again,
contact a qualified electrician.
Replace the lamp.
1. Deactivate the oven.
2. Press and hold
3. Press and hold
• Deactivate the oven with the
house fuse or the safety
switch in the fuse box and ac-
tivate it again.
• If the display shows the error
code again, contact the Cus-
tomer Care Department.
Adjust the temperature if neces-
sary. Follow the advice in the
user manual.
Do not leave the dishes in the
oven for longer than 15 - 20 mi-
nutes after the cooking process
ends.
The necessary data for the service centre is on
the rating plate. The rating plate is on the front
frame of the appliance cavity. Do not remove
the rating plate from the appliance cavity.
.........................................
.........................................
.........................................
Remedy
until the
appliance activates and re-
turn to the standby mode.
and
the same time until the
acoustic signal sounds again
and the indicator goes out.
at
21