Table of Contents
Advertisement
TeamPos 3000XT
Chapter 8 - Troubleshooting
8.1
Power cannot be turned on or the unit powers off after a few
minutes.
The power LED next to the power switch does not light up.
NOTE: Assume Windows operating system and OPOS/JavaPOS.
No
Check item
Is the power cable connected?
1.
Is there power to the AC outlet?
2.
(Test with device known to work.)
Does the power shut off after a few
3.
minutes?
Go into the BIOS by hitting "F2"
during boot up and "Load
4.
Optimized Defaults". Does the
power stay on?
Go into the BIOS ("F2") and go to
the "hardware monitoring" section.
5.
Are there any warnings or readings
close to a warning?
Check pins on Docking Backplane
connectors to insure they are not
6.
bent or shorted. Are any pins bent or
shorted together?
Can the power be turned on after
7.
replacing the power supply unit?
Can the power be turned on after
8.
replacing the motherboard?
Caution: Before replacing any boards, unplug the power cable and make
D900000172
sure the motherboard standby power LED light is out.
Installation and Maintenance Manual
Judgment
Action
Y
Go to No. 2.
N
Connect the power cable.
Y
Go to No.3.
N
Turn on power to the distribution
panel.
Y
Go to No. 4.
N
End.
Y
End.
N
Go to No. 5.
Y
Correct situation (ex. remount
heatsink, clean vents, etc.) –
End.
N
Go to No. 6
Y
Replace barebones whole unit.
N
Go to No.7.
Y
End.
N
Go to No. 8.
Y
End.
N
Replace barebones whole unit.
8-1
Advertisement
Table of Contents
