Table of Contents
Advertisement
TeamPoS 3000
7.2.1.
Powering On
1. Make sure all peripherals are securely connected to the control unit.
2. Make sure the power cord is plugged into the power source.
3. Lift the plastic switch cover at the left side of the control unit.
4. Press the power switch to turn the terminal ON.
5. Confirm the power/battery status LED is lit solid, indicating the successful completion of
power-up diagnostics.
Note: Some peripherals, such as scanners and scales, may be separately powered. Check the
peripheral manuals for instructions on powering on these peripherals.
Any hardware errors detected on power up will appear on the operator display (LCD). Note that
the model VF 60 two-line alphanumeric display does not display error messages.
Note: Depending on setup, a momentary depression of the switch may signal the application to
shut the unit down, which could take a few minutes. If power is not immediately turned off,
either wait for the application to shut the unit down, or keep the switch depressed for
approximately 4 seconds. For proper shutdown procedures, see the application software
documentation.
7.2.2.
Powering Off
1. Lift the plastic switch cover.
2. Press the power switch to turn OFF the terminal.
Note: For proper shutdown procedures, see the application software documentation.
7.3.
Replacements
Subassemblies in the TeamPoS 3000XT cannot be repaired in the field, only replaced. For these
tasks, you will need only a Phillips head screwdriver and a small flat blade screwdriver to
replace the CPU and heat sink. The following sections provide details on the following tasks:
• Replacing the motherboard and changing motherboard settings
• Adding or replacing memory
• Replacing the hard drive
• Replacing the power supply
• Replacing the MSR or MSR/Keyboard (see Chapter 5)
7-2
MAINTENANCE MANUAL
D900000172
Advertisement
Table of Contents
