Figure 83
1. Adjustment bolt
2. Jam nut
3. Yoke
1
2
3
4
g020807
4. Deck hanger arm
5. The distance needs to be
11 mm (7/16 inch).
Adjusting the Right Side Front-to-Rear
Mower Deck Pitch
1. Position the right blade front-to-rear
2. Measure the right blade at the C location, from a level
surface to the cutting edge of the blade tip, and record
this measurement
3. Measure the right blade at the D location, from a level
surface to the cutting edge of the blade tip, and record
this measurement
Note: The mower blade should be a 6 to 10 mm
(1/4 to 3/8 inch) lower at position C than at position
5
D
(Figure
following steps.
4. Loosen the jam nuts at the right and left front swivels.
5. Using the right jam nuts, adjust the length of the right
threaded rod to achieve the 6 to 10 mm (1/4 to 3/8
inch) front-to-rear pitch.
6. Tighten the jam nuts at the right and left front swivels.
1. Measure here from blade
to hard surface.
55
(Figure
84).
(Figure
84).
84). If it is not correct, proceed to the
Figure 84
2. Measure at C and D.
(Figure
84).
g020858