Toro GrandStand 79534 Operator's Manual page 48

1
Figure 70
1. Left motion-control lever
2. Right motion-control lever
2. Ensure that the right motion-control lever moves easily
into the N -
EUTRAL LOCK
Note: Turn the cable adjustment clockwise to
move the motion-control handle forward. Turn
the cable adjustment counterclockwise to move the
motion-control handle rearward.
3. Rotate the cable adjustment on the right side when
adjustment is needed.
Note: Adjust the cable adjustment in quarter-turn
increments.
4. After the right motion-control lever moves easily
into the N -
EUTRAL LOCK
motion-control lever to align it with the right
motion-control lever.
5. Check for proper tracking; refer to
Tracking (page 39).
6. Install the cable lock onto the cable-adjusting nuts to
secure the adjustment
2
3
4
G012706
3. Neutral-locked position
4. Align the control levers
front to back
position.
position, adjust the left
Adjusting the
(Figure 71).
1. Left cable adjustment
2. Cable lock
48
Figure 71
3. Right cable adjustment