Side Discharging Or Mulching The Grass; Adjusting The Height Of Cut - Toro GrandStand 79534 Operator's Manual

6
Figure 27
1. Full-width ramp in stowed
position
2. Side view of full-width
ramp in loading position
3. Not greater than
15 degrees
1
2
5
4. Ramp is at least 4 times
as long as the height of
the trailer or truck bed to
the ground
5. H= height of the trailer or
truck bed to the ground
6. Trailer
Side Discharging or Mulching
the Grass
This mower has a hinged grass deflector that disperses
clippings to the side and down toward the turf.
DANGER
Without the grass deflector, discharge cover, or
complete grass catcher assembly mounted in
place, you and others are exposed to blade contact
and thrown debris. Contact with rotating mower
blade(s) and thrown debris cause injury or death.
• Do not remove the grass deflector from
the mower, because the grass deflector
routes material down toward the turf. If the
grass deflector is ever damaged, replace it
immediately.
• Never put your hands or feet under the mower.
• Never try to clear the discharge area or mower
blades unless you release the bail and the power
takeoff (PTO) is off. Rotate the ignition key
to the O
disconnect the wire(s) off the spark plug(s).
g027996

Adjusting the Height of Cut

The height of cut can be adjusted from 25 to 127 mm (1 to 5
inches) in 6 mm (1/4 inch) increments.
1. Move the height-of-cut lever to the transport position
(all the way up).
2. Rotate the pin 90 degrees and remove it from the
height-of-cut bracket.
3. Select a hole in the height-of-cut bracket corresponding
to the height-of-cut desired and insert the pin
28).
4. Push the button on top and lower the height-of-cut
lever to the pin
24
position. Also remove the key and
FF
(Figure 28).
(Figure