Operating The Mower-Blade-Control Switch (Pto); Operating The Throttle; Operating The Choke - Toro GrandStand 79534 Operator's Manual

Operating the
Mower-Blade-Control Switch
(PTO)
The blade-control switch (PTO) is used in conjunction with
the right motion-control lever to engage and disengage the
mower blades.
Engaging the Mower Blades (PTO)
1. To engage the mower blades, move the right
motion-control lever to the center, unlocked position.
2. Pull the blade-control switch (PTO) up and release it
while holding down the right motion-control lever in
the center, unlocked position.
Disengaging the Mower Blades (PTO)
The following are 2 options for disengaging the mower blades:
•
Push the blade-control switch (PTO) down to the O
position (Figure 10).
•
Move the motion-control levers to N
the right motion-control lever into the N
position (Figure 11).
G008945
Figure 9
g012782
Figure 10
and move
EUTRAL
EUTRAL

Operating the Throttle

The throttle control moves between F
(Figure 12).
Always use the F
blades with the blade-control switch (PTO).
FF

Operating the Choke

Use the choke to start a cold engine.
1. If the engine is cold, use the choke to start the engine.
2. Pull up the choke knob to engage the choke before
using the ignition switch
3. Push down the choke knob to disengage the choke
after the engine has started
-
LOCK
16
g012895
Figure 11
and S
AST
position when engaging the mower
AST
G008946
Figure 12
(Figure 13).
(Figure 13).
positions
LOW