Toro GrandStand 79534 Operator's Manual page 40

Figure 56
1. Left cable adjustment
2. Cable lock
7. Check for proper tracking.
Note: If the machine does not start after adjusting the
tracking, make sure that the proximity switch target
aligns with the bolt attached to the motion-control
lever; refer to Adjusting the Proximity Switch (page
8. Repeat the cable adjustment until the tracking is
correct.
9. Check that the machine does not creep from neutral
with the park brakes disengaged.
Important: Do not rotate the linkage too far, as this
may cause the machine to creep in neutral.
Adjusting the Proximity Switch
Use this procedure if the machine does not start after
adjusting the tracking.
1. Ensure that the bolt attached to the motion-control
lever aligns with the proximity-switch target
2. If needed, loosen the bolts and adjust the proximity
switch until the target aligns with the bolt attached to
the motion-control lever
3. Check the distance of the bolt to the proximity switch;
it needs to be between 0.51 to 1.02 mm (0.02 to 0.04
inches) as shown in
4. If adjustment is needed, loosen the jam nut and adjust
the bolt to the correct distance.
5. Tighten the jam nut after adjusting the bolt
3. Right cable adjustment
(Figure
(Figure 57).
Figure 57.
(Figure
6. Test the safety-interlock system before operation.
1 6
g017848
2
40).
1. Proximity-switch target
2. Proximity switch
3. Bolts and nuts
57).
57).
40
2 3 4
6
4
5
G015609
Figure 57
4. Bolt attached to the
motion-control lever
5. 0.51 to 1.02 mm (0.02 to
0.04 inches)
6. Jam nut