Nokta Simplex LITE User Manual page 22

OPTIONS
In all the versions of the SIMPLEX, to access the
Options, press the Power & Settings button to go
into settings and then use the right and left buttons
to select the Options. Next, you can press the Ground
Balance / Confirm button to access the upper settings.
Once you are in the upper settings, you can use the
right and left buttons to select any setting you want.
While in the upper settings, you can press the Pinpoint
/ Back button to go back to the main settings or go
back to the main screen by pressing the Power &
Settings button.
Bluetooth® ( BT/ULTRA)
This setting, which is not available in the LITE version,
is used to turn on and off the Bluetooth® headphones
connection.
After choosing the Bluetooth® connection setting, you
can turn on or off the connection with the plus (+)
and minus (-) buttons. When it is off, the box will be
highlighted in black and when it is on, it will be white.
4 99
4 99
For more detailed info about the wireless headphones,
please read the instructions included with the
headphones.
The Bluetooth® setting is restored to the final saved
setting when the device is turned off and on again. This
setting is common in all modes; change made in any
mode also applies to the other modes.
Vibration
This feature provides feedback to the user by producing
a vibration effect when a target is detected. It can be
used independently or together with the audio response.
When audio response is disabled, all responses during
target detection are provided to the user as vibration
only.
When the Vibration is turned on, the device provides
short vibration signals upon target detection. The
magnitude of the vibration effect can vary according
to the depth of the target and the swinging speed. This
setting is common in all search modes.
To turn on or off the Vibration, after selecting vibration
in the settings menu, use the plus (+) and minus (-)
buttons. When it is off, the box will be highlighted in
black and when it is on, it will be white.
Vibration may not be felt in the All Metal mode with
weak signals; it will be felt as the signal gets stronger.
In other words, vibration does not start at the depth
where the audio tones are heard but at a lesser depth.
Therefore, if you are detecting with vibration only and
audio tones are off, you can miss weaker and deeper
signals.
NOTE: It is recommended that you swing the detector
more slowly while using the vibration to prevent
missing targets.
20
4 99