Eaton Power Xpert IGX Instruction Booklet page 22

Instruction Booklet
IB022023EN
Effective April 20232
Revision #21
5. Turn the Manual Operation T-Handle clockwise to move the
switch from Disconnect to Connect (See Figure 20).
6. Once the closed position has been reached remove the
Manual Operation T-Handle (Figure 21).
7 . Restore the Selector Key to its neutral position (neither
Connect nor Ground position). Remove the Selector key.
Rotate the Selector Key Port Cover to its closed position.
8. Slide the padlock hasp back to its Lock position and apply a
padlock if appropriate.
22
EATON www.eaton.com/IGX
Instructions for the installation and
commissioning of Power Xpert IGX
CW
to
close
Figure 20. Rotate manual operation t-handle to close.
Figure 21. Remove manual operation t-handle.
medium-voltage switchgear
Removing T-Handle
after closing switch