Optimal Operation; Interior Chambers - United States Stove US5513 Owner’s Instruction And Operation Manual

Table of Contents

Advertisement

Available languages

Available languages

OPERATION INSTRUCTIONS

OPTIMAL OPERATION

This pellet stove has been certified by the US EPA to
meet strict 2020 guidelines. To Insure this unit produces
the optimal minimal emissions, it is critical to follow the
following guidelines.To achieve a "high burn" your stove
should be set on setting 5 with the damper fully open.
To achieve a "medium burn" your stove should be set
on setting 1 with the damper fully closed.To achieve a
"low burn" your stove should be set on setting 1 with the
damper closed.Settings 2, 3 & 4 will give you a higher
heat output above medium and the damper should be
open for these settings. If the door is opened while the
stove is in operation it must be closed within 30 seconds
or the stove will shut down. If the stove shuts down push
the "On/Off" button to re-start your stove. The stove will
have to fully shut down and turn off before you will be
able to restart the stove

INTERIOR CHAMBERS

• Burn Pot - Periodically remove and clean the burn pot
and the area inside the burn pot housing. In particular,
it is advisable to clean out the holes in the burn pot to
remove any build up that may prevent air from moving
through the burn pot freely.
• Heat Exchanger - There is a clean out plate on both
sides of the heat exchanger that need to be removed to
clean fly ash out of the heat exchanger. The cleanouts
are located inside the cabinet doors, on the lower
front corners of the heat exchanger. To access these
clean outs, you must remove both side panels. The
clean outs are secured to the firebox with (2) 5/16"
screws. Remove the clean outs and vacuum out any
accumulated ash. This should be done at least once per
month or more frequently if large amounts of ash are
noticed while cleaning or if the stove does not seem to
be burning properly.
If a vacuum is used to clean your stove, we suggest
using the AV15E AshVac vacuum. The AV15E AshVac is
designed for ash removal. Some regular vacuum cleaner
(i.e. shop vacs) may leak ash into the room.
DO NOT VACUUM HOT ASH.
FAILURE TO PROPERLY MAINTENANCE THE CLEAN
OUTS WILL RESULT IN POOR PERFORMANCE OF
15
© 2022 United States Stove Company
WARNING:
THIS STOVE.

Advertisement

Table of Contents
loading

Table of Contents