Electrolux Y62IS443 User Manual page 81

First set the heat setting for one of the left
side cooking zones.
To activate the function: touch
change the heat setting touch one of the
control sensors.
To deactivate the function: touch
cooking zones operate independently.
6.7 Automatic Heat Up
Use the function to get a desired heat setting
in a shorter time. When the function is on, the
cooking zone operates at the highest heat
setting in the beginning and then continues to
operate at the desired heat setting.
To activate the function the cooking zone
must be cold.
To activate the function for a cooking
zone: touch (
touch a desired heat setting. After 3 seconds
comes on.
To deactivate the function: change the heat
setting.
6.8 PowerBoost
This function makes more power available to
the induction cooking zones. The function can
be activated for the induction cooking zone
only for a limited period of time. After this time
the induction cooking zone automatically sets
back to the highest heat setting.
Refer to "Technical data" chapter.
To activate the function for a cooking
zone: touch .
To deactivate the function: change the heat
setting.
6.9 SenseBoil®
The function automatically adjusts the
temperature of water so that it does not boil
over once it reaches the boiling point.
. To set or
. The
comes on). Immediately
comes on.
If there is any residual heat (
) on the cooking zone you want to
use, an acoustic signal is emitted and the
function does not start.
1. Touch to activate the hob.
2. Touch to activate the function.
A blinking appears for cooking zones
on which you can presently use the
function.
3. Touch the control bar of any available
cooking zone for which you want to start
the function (between the heat setting
1-14).
The function starts.
If you do not choose any cooking zone within
5 seconds the function does not activate.
Once the function starts the indicators
above the symbol come on one after
another until the water reaches the
boiling point.
When the function detects the boiling point
the hob emits an acoustic signal and the heat
level automatically changes to 8.
If all cooking zones are already in use or
there is some residual heat on all of
them, the hob emits a beep sound, the
indicators above
function does not start.
To deactivate the function touch
function deactivates and the heat setting
goes down to 0) or touch the control bar and
adjust the heat setting manually.
6.10 Timer
• Count Down Timer
You can use this function to set the length of
a single cooking session.
First set the heat setting for the cooking zone,
then set the function.
/ /
blink and the
(the
ENGLISH 81