Tools Required; Procedure; Disassembly - Nortel NetVenue Manual

2-16 Front assembly
Figure 2-12: Card reader with bezel flowchart
Loosen wire harness
Open PCP assembly
and disconnect cables
Remove card reader
bezel screws
Remove bezel and
card reader
Install new card reader
and bezel
Reconnect cables and
close PCP assembly

Tools required

Procedure

Disassembly

Issue: 01.01 Standard Date: September 1999
• #1 Type 1A cross-recess screwdriver such as a Phil-
lips
The procedure for replacing the lower keyboard bezel is
broken down into disassembly and reassembly.
The following procedure describes the steps for removing
the old card reader and bezel.
1. Remove the wiring harness from the fasteners on ei-
ther side of the card reader to allow some room to
work.
2. Remove the screw ontop of the telephony component.
Figure 2-13 shows the location of this screw.