Table of Contents
Advertisement
ts_Book Page 7 Tuesday, February 16, 1999 9:30 AM
Do not reconnect the power until you are
ready to close the terminal to run the craft
interface and terminal tests.
Tools
Below is a list of the tools needed to main-
tain the Millennium terminals:
• chip puller
• multimeter
• ESD strap
• T- or L- tool
• dial test set
• cleaning card
• small slot-head screwdriver
• #1 type 1A cross-recess screwdriver
• #2 type 1A cross-recess screwdriver
• 5/32-inch hex wrench
• portable display (Coin basic/Inmate)
Replaceable modules
The terminal components are designed in
replaceable modules. These include:
• customer-specific lock for the housing
• hookswitch/alerter bezel assembly
• alerter PCP
• upper bezel assembly
• handset/cord assembly/swivel assembly
• number card/instruction card, provided
by telco
Millennium terminals pocket troubleshooting guide
Before you start — 7
• butt-end test set
• 7/16-inch wrench
• 7/8-inch wrench
• wire cutters
• electrical tape
• test cards
Advertisement
Table of Contents
Troubleshooting
