Suggested Tools And Equipment; Table 2-3: Recommended Tools And Equipment - Nortel Millennium Card Manual

insbk202 Page 7 Tuesday, February 16, 1999 8:15 AM

Suggested tools and equipment

Table 2-3: Recommended tools and equipment

Tool
T-tool /L-tool
upper housing and lower
housing keys
butt-end test set
multimeter
ESD wrist strap
dry type cleaning card
test cards: mag stripe and
smart card
knuckle saver (lifter)
small slot-head screwdriver
#1 type 1A cross-recess
screwdriver
#2 type 1A cross-recess
screwdriver
chip puller
external portable display
Table 2-3 lists the tools and equipment required for install-
ing, maintaining, and testing the terminal.
Use to
open the housing assembly
unlock the terminal housing; used in conjunc-
tion with the T- and L-tool to open the terminal
test the line to the terminal, and to use during
fault-clearing procedures
measure the voltage of the supplementary
power supply
protect electronic components from electro-
static discharge (ESD) damage
clean the card reader.
test the ability of the terminal to process card
calls
remove external instruction cards
attach the tip and ring leads and the supple-
mentary power supply leads to the terminals on
the rear terminal board
tighten and loosen M3 screws and to remove
the number-card window
tighten and loosen M3.5 screws and M5 screws
replace control and voice chips on the control
PCP
access craft interface prompts on the Inmate
terminal
Millennium Card-based terminals: installing terminal hardware
Pre-installation overview 2-7