Table of Contents
Advertisement
VWFST Series Vented Gas Log Set
FILLING THE BURNER PAN
Fill the burner pan with vermiculite to the center and sloped
to the front/back of the burner pan. Excess vermiculite can
spill forward or to the sides of the burner pan. Do not overfill
the propane model. Do not cover the pilot with vermiculite
or rock wool (embers).
PLACEMENT OF GLOWING EMBERS
(ROCK WOOL)
The Wildfire flame appearance can vary due to differences
in draft and fireplace configurations and ember placement.
After installing the four (4) bottom logs, cover the entire top
surface of the vermiculite in the burner pan with the rock
wool supplied with unit. Tear the rock wool into pieces ap-
proximately 1/2" in size (roughly the size of a nickel) and
cover the burner evenly. Do not use more rock wool than
the amount supplied with the unit. To enhance the ap-
pearance of the Wildfire flame, it is recommended to form
a mound of rock wool in the center of the burner, 2" to 3"
high, visible through the logs.
VWFST18ST and VWF24ST LOG PLACE-
MENT
1. Place bottom left log (#1) and bottom right log (#2) on
front of grate. Figure 16
Bottom Right Front
Log #2
14
Bottom Left Front
Log #1
Figure 16
Bottom Left Front
Log #1
PLACEMENT OF DECORATIVE VOLCANIC
ROCK
S p r i n k l e
v o l c a n i c
DO NOT SPRINKLE ON BURNERS, EMBER BED, PILOT
OR LOGS.
IMPORTANT: Do not handle logs with your bare hands!
Always wear gloves to prevent skin irritation from
ceramic fibers. After handling logs, wash your hands
gently with soap and water to remove any traces of
fibers.
Bottom Right Front
Log #2
2. Place bottom left front log (#1) behind bot-
tom right front log (#2) on back of grate.
Figure 17
LG1058
3. Place bottom right front log (#2) behind
VWFST front logs
bottom left front log (#1) on back of grate.
Figure 17
Figure 17
LG1060
LOG PLACEMENT
a r o u n d
t h e
b u r n e r .
LG1059
LG1059
27D8851
Advertisement
Table of Contents
