Stone, Light Bulb And Lens Placement; Rock Wool Placement - Vermont Castings VHLDV500 Installation And Operating Instructions Manual

Resolution Direct Vent Gas Fireplace
stOne, LIGHt BuLB, anD Lens pLaceMent
1. Remove the trapezoidal light shroud located at the back of the firebox by unfastening the three
screws.
2. Disassemble the trapezoidal light shroud by unfastening the four screws which secure the front
to the back. Set lens with the orange painted surface toward the bottom. Center the lens right to
left. Reassemble the front to the back and set the side.
3. Place the right side panel by sliding it at an angle to clear the grate. Set the panel straight up and
bring forward until it comes in contact with the reverse bend located at the front of the firebox.
Use one of the brackets and screws provided to secure the panel in place.
4. Place the rear lower panel by setting it over the channel behind the light socket. Make sure the
grout line lines up with the one on the side.
5. nOte: Have the left panel bracket and screw handy before installing the rear upper panel
in place. Place the rear upper panel in place by resting it over the rear lower panel and sliding
it behind the right side panel. While holding the rear upper panel in place, slide the left panel at
an angle to clear the grate. Set the left side panel straight up and release the rear upper panel.
Secure the left side panel in place using the second bracket and screw provided in the kit.
6. Loosen the four (4) screws securing the grate to burner and place the front hearth brick simul-
taneously and pull toward the front away from the burner. This is critical for balancing air flow
around the front burner. Retighten the grate screws.
7. Install the halogen light bulb provided with the unit (inside the log set). Do not touch light bulb
directly with fingers.
8. Replace the trapezoidal light shroud removed in step #1 by sliding it over the light bulb and
sockets. Be careful not to damage the light bulb. Align the holes on the deflector with the hole
on the rear channel and secure in place.

ROcK wOOL pLaceMent

1. Place rock wool on the front burner to provide glowing
embers. For best results, pull the rock wool apart into
dime size pieces and place on top of burner. Also place
the same size ember over the carry over parts on the rear
burner. Do nOt place embers over open slots on the
rear burner.
2. Distribute one layer of rock wool to cover the burner.
Figures 35 & 36
3. Place the logs on the burner. Refer to Log Placement.
Light unit and after 15 minutes, check burner flame and
glow. Refer to Burner Flame, Page 44.
Do not use the entire bag of rock wool to
cover the burner. this could cause the flame
to burn poorly and may lead to sooting.
28
FInaL InstaLLatIOn
Figure 35 -
Rockwool placement
FP2155
ember placement
FP2155
20300293