Pipe Connection - ADURO H3 LUX User Manual

Distance to flammable material (see also illustration below)
Behind the stove
7,5 cm
To secure access to inspection openings and enough air for the combustion, there needs to be a distance of
at least 8 cm to the wall behind and 60 cm to the side. However, to ensure easy access during service and
cleaning, we recommend keeping a distance of min. 10 cm to the wall. You must be prepared to dismount
the flue pipe and turn the stove during the yearly inspection and by maintenance.
Please ensure that all local rules and regulations are complied with, including CE marking of the exhaust
connector. Additionally, distance requirements to flammable material for the exhaust connector must be
respected.
If the Aduro H1 & H3 LUX is to be placed close to flammable material such as a wooden floor or carpet it
must be placed on a non-flammable base. The floor plate should extend for at least 30 cm in front of the
Aduro H1 & H3 LUX and 15 cm on each side – measured from the combustion chamber opening.
The Aduro H1 & H3 LUX must be installed on a floor with the adequate load-
bearing capacity. If the existing construction does not meet this requirement,
appropriate adaptation measures must be taken (e.g. a load-distributing plate).

2.2 Pipe connection

Aduro H1 & H3 LUX leaves the factory with the flue outlet mounted on the top. If you require the flue outlet
on the back, remove the round circle from the rear cover at the upper rear of the stove and then exchange
the exhaust connector (located on the top outlet above the stove) with the cover plate (that covers the rear
outlet). The top outlet is finished with the plate that lies in the ash pan. We recommend that you place a thin
gasket between the flue pipe and exhaust branch. A flue pipe with an internal diameter of 150 mm should be
To the sides of the stove
70 cm
To furniture
100 cm
54